Simple 4-Step Installation Guide

Step 1. Prep the Surface: Wipe your surface clean with a damp cloth and let it dry completely. For the best bond, ensure the area is smooth and free of dust or grease.

Step 2. Measure & Cut: Use the grid lines on the back to cut the paper to size, leaving an extra 1 inch at the edges for easy trimming later.

Step 3. Peel & Stick: Peel back just 6 inches of the backing. Align it to the top, stick it down, and slowly peel the rest while smoothing from the center outward with a squeegee or soft cloth.

Step 4. Trim the Excess: Once the surface is covered, use a sharp blade to trim the edges for a professional, seamless fit.

Pro Tips for a Flawless Look

* The Hairdryer Trick: Use a hairdryer on low heat for corners or curved edges. The heat makes the vinyl pliable, allowing it to mold perfectly to the shape.

* Fixing Bubbles: If you spot a stubborn air bubble, don't panic. Just pierce it with a tiny pin and smooth the air out—the matte finish will hide the hole completely.

How to Remove (Damage-Free)

Use a hairdryer to warm the surface for a few seconds. This softens the adhesive so it pulls away easily. Then start from a corner and peel back slowly at a 45-degree angle.